Malossi Clutch Bell Lamellae Int 130 Clutch bellRef : MAL00817A / 1129655

Clutch Bell Lamellae Int 130 by Malossi

Reinforced clutch bell equipped with a cooling ring and fins to enhance heat dissipation. The stamped steel housing and nitrided friction surface provide increased wear resistance. Designed for satisfactory starting behaviour and improved low-rev acceleration under demanding conditions.

Design and materials

• Robust stamped steel housing offering a structure resistant to mechanical stress for reliable dimensional stability.
• Special steel gear for shaft, welded and reworked, for precise coupling and smooth motion transmission.
• Machined friction surface with minimal tolerances for more consistent clutch engagement.
• Nitrided friction surface for better wear resistance and increased longevity of contact surfaces.

Usage and performance

• Finely ribbed reinforcement ring increasing the thermal dissipation surface to reduce operating temperature.
• Cooling fins designed to expel heat and promote satisfactory starting behaviour as well as efficient low-rev acceleration.
• Dynamic balancing to limit vibrations and preserve riding comfort and component lifespan.

Safety and standards

• Product intended solely for competition in designated locations in accordance with the provisions of the relevant sporting authorities; any improper use is not covered by the manufacturer's liability.
• Ensure compliance with applicable regulations and technical checks in competition before installation.

Advantages

• Design resulting from extensive track testing, tailored to withstand high loads and extreme stresses.
• OEM reference 7717083B

Examples of compatible motorcycles

• KYMCO DTX 125 (2026 - 125 cm³)
• KYMCO X-TOWN CITY 125I (2025 - 125 cm³)
• KYMCO DTX360 125 (2025 - 125 cm³)

Complete list of compatible motorcycles available in the dedicated section below