The battery is supplied complete with an acid pack and fixing screws.
The battery is supplied in a dry, pre-charged state. Please use the battery acid provided for filling.
Remove the protective film from the battery and detach the battery sealing strip from the acid. Pour in the acid and let it stand for about 30 minutes to enable the air to escape properly.
Place the sealing strip from the acid into the openings on the battery and seal it firmly. Install the battery and start the engine. In this state, the battery is not at full power (about 70%), but it will enable the engine to be started a number of times without any problems.

The battery is supplied in a pre-charged state and is not at full power. Before installation, please charge to full power using a compatible motorbike charger (at least with automatic switch-off).
Battery type:

• 12 V, 10 Ah
• Length x width x height: 152 x 88 x 131 mm
• Terminals: positive on the left, negative on the right