Denali 3 pin Male Connector Universal LightsRef : DENA00083A / 1079870

Reference: DNL.WHS.050 — Brand: DENALI

Waterproof male 3-wire connector specifically designed for adapting lighting from other brands to the DENALI CANsmart controller. This pre-assembled harness simplifies the connection of additional lights by providing a clean, ready-to-use solution for electrical integration.

• Connector: male 3-pin, waterproof
• Wires: 3 conductors of 0.8 mm² section
• Usage: to solder to the accessory of your choice and interface with the DENALI CANsmart controller

Ideal for motorcyclists looking to install or replace additional optics while retaining DENALI electronics. The cord comes out with three bare wires, allowing for clean soldering and insulation of the connection (heat shrink, crimping, and sealing recommended) and ensuring a tidy route on the motorcycle.

Installation and practical tips: identify the polarities and ground wire before soldering, protect the connection points against moisture and vibrations, and position the connector to minimize friction. Compatible as a mechanical/electrical interface; check the compatibility of signals and voltages with your accessory before installation.