Techno Mousse uses a new additive in its rubber mixture that allows the foam to heat up less.

• Dimension: 90/90-21
• Weight: 940 g
• Position: front
  
• Pressure: 0.9/1.0 bar
  
• They deform less
• They last longer
• They lose much less volume over time
• They are always without an expiration date
• Italian manufacturing
• For off-road or enduro use only
• Unique technology (vulcanisation)
• Lightweight
  
• Very good wheel feel for smooth handling
• Multiple qualities, offering different pressures depending on the terrain and the machine

The hardness degree of the techno foams reaches their maximum elasticity after a few minutes of use (more or less depending on the outside temperature and riding).
It is strongly recommended to leave the motorcycle on a central stand for at least 45 mm once riding is finished. The techno foam will thus regain its original shape and hardness.
Never strap the motorcycle with techno foams that are still hot.
It is recommended to mount the tyre with gripsters in good condition and properly tightened.
The techno foams are not approved for use on paved roads.
The techno foams are made with elastic material.
When changing tyres, you may notice that the front and rear foams are not in the same condition and/or not in their original shape.
Once the new tyres are mounted, the techno foams will adapt to the new tyre.

Mounting advice:

• Generously grease the inside of the tyre with the provided silicone gel
• Thoroughly cover the foam with the provided gel
• Insert the techno foam into the tyre
• Place the wheel on the tyre and insert the lower edge of the tyre with appropriate tyre levers
• Engage the other shoulder of the tyre with a tyre lever and lock it
• On each side of the fixed tyre lever, engage the tyre once to the right, once to the left until it is fully seated