• Red anaerobic viscous gel.
• The gasket hardens completely, making it highly resistant to pressure (up to 300 bar).
• Replaces the usual solid seals.
• High-quality sealing.
• Extra protection against corrosion.
• Temperature resistance from -55 to +150°C.
• Can fill surface defects up to 0.5 mm.

Red gel for flat surfaces, parting lines, passive surfaces, active surfaces.

• Use on a clean, dry surface
• Apply the product to the surface to be sealed.
• Assemble the parts and allow to harden.
• Immediate assembly is not mandatory, as the seal only reacts after the parts have been assembled.
• Drying time: 10 to in 20min. Final curing time: 12h

Dangerous, follow safety precautions.

Signal word (CLP):

• Attention

Contains:

• 2'-PHENYLACETOHYDRAZIDE; 2,2'-ETHYLENEDIOXYDIETHYL DIMETHACRYLATE; Methacrylic acid, monoester with propane-1,2-diol

Hazard statements (CLP):

• H317 - May cause skin allergy.
• H319 - Causes severe eye irritation.

Safety advice (CLP):

• P101 - If a doctor is consulted, keep the container or label available.
• P102 - Keep out of the reach of children.
• P260 - Do not breathe vapours.
• P264 - Wash hands thoroughly after handling.
• P280 - Wear protective gloves and eye and face protection.
• P301+P310 - IF SWALLOWED: Call a POISON CENTER or doctor immediately.
• P302+P352 - IN CASE OF CONTACT WITH SKIN: Wash thoroughly with water.
• P305+P351+P338 - IN CASE OF CONTACT WITH EYES: Rinse carefully with water for several minutes. Remove contact lenses if worn and easily removable. Continue rinsing.
• P333+P313 - If skin irritation or rash occurs: seek medical advice.
• P337+P313 - If eye irritation persists: seek medical advice.
• P362+P364 - Remove contaminated clothing and wash before reuse.
• P501 - Dispose of contents/container in a hazardous or special waste collection centre